PV Powered PVP2000 Spezifikationen PDF herunterladen (Seite 6)

PV Powered LLC 5 32-29-28-20-306

CAUTION:

To reduce the risk of fire, connect the PVP3200, PVP2900 and PVP2800-XV to a circuit

with 20 amps maximum branch-circuit overcurrent protection and the PVP2000 to a

circuit with 25 amps maximum branch-circuit overcurrent protection in accordance with

the National Electrical Code (NEC), ANSI/NFPA 70.

2.2.a Steps to Mount the StarInverter

1. Locate the wall studs in the desired location and align the mounting bracket

over the studs. Mark the mounting holes. Ensure that locations A and B (as

indicated in Figure 2 below) are aligned over the wall studs.

2. MAKE SURE BRACKET IS LEVEL. Ensure points A and B are aligned with wall

studs. Drill 1/8”pilot holes for the screws. Use heavy-duty ¼” x 2”coarse

thread lag screws to secure points A and B to the wall. Use an 1/8” screw to

secure point C. See Figure 2.

Figure 2: Mounting Bracket

5. Carefully hang the inverter on the upper part of the bracket so that the hooks

located at the rear of the inverter hang over the bracket.

6. Verify inverter is level.

7. Remove the front cover of the StarInverter by unscrewing the two cover screws

located at the bottom of the inverter.

8. Locate the two inverter mounting holes below the power board. (See Figure 3)

Insert the two mounting screws through the inverter and tighten securely.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Keine Kommentare

PV Powered PVP2000 Spezifikationen Seite 6