PV Powered 5200 Handbuch PDF herunterladen (Seite 15)

Installation

Step1: Drill holes in the wall with drill machine according to the size of bracket. Drill straight into the wall

do not shake the drill to avoid damage to the wall. Depth of the holes should be about 30mm and should

be the same in all the holes. After removing dust from the holes, measure the net depth of the holes. If

the depth is more than 33mm or less than 27mm, the expansion pipes can not be properly installed.

Position Min. clearance

Side

Top

Bottom

Front

30cm

10cm

Table 2 Minimum clearance needed

6.3 Preparation

6.4 Installation Steps

Following tools are needed for installation.

Installation Tools: Crimping tool, Plier, Screwdrivers and adjustable spanner and Drill machine.

Installation Tools

Inverter needs at least 30cm (see table 2) clearance. If this is not observed, inverter is likely to malfunction

high temperature inside the inverter. Samil Power will not cover any damage due to this condition.

●

Not exposed to direct cool air.

Not close to television antenna or antenna cable.

● SolarRiver 2300TL~5200TL Models

Figure 9 Installation of Expansion Pipe

1 Expansion Screw

2 Expansion Pipe

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Keine Kommentare

PV Powered 5200 Handbuch Seite 15